After (or before) activate bset and put the pre-amp where you want it, the switch off bset. The preamp will stay on, but you only have the indication when you activate bset. Willis 'Cookie' Cooke K5EWJ
________________________________ From: Gary Smith <[email protected]> To: [email protected] Sent: Wed, February 24, 2010 3:42:22 PM Subject: [Elecraft] Pre for the Rx ant only? when I am using my Rx ant into the sub receiver, I click sub and then hold Rx-ANT till it says AUx. I have my beverage connected to the BNC port below ANT2. If I want to have the K3 preamp on for this Rx antenna but not have it on for the Inverted L, how do I engage the second receiver so it alone has the preamp engaged? I don't want the noise from my transmit antenna amplified. I am mostly working diversity. Thanks, Gary KA1J ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
