Hi Frank. Make sure the mark tone frequency your software is set up for matches the mark tone frequency the K3 is set for. In AFSK-A mode, use the PITCH button (i.e. press and hold the SPOT button) to check and set the AFSK mark frequency.
See the section titled "Mark/Shift and Pitch Selection" on page 31 of the K3 Owners Manual. 73 -- Joe KB8AP On Feb 10, 2010, at 10:11 AM, Frank R. Oppedijk wrote: > ...so I tweaked the necessary controls on > my K3 and on my PC soundcard. But no transmit output?! The PTT is > asserted and the receiver is muted, but no transmit output and no > monitor output. ... > ... I found out that everything was > working fine when I changed the DATA MD from AFSK A to DATA A!... > Can anyone help me out? What setting or control can be the cause of > this? > > Thanks in advance, > > Frank PA4N > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
