Gang: Need a little help to clarify the set-up on my XV50. Page 72 of the manual gives initial set-up for the shorting blocks to configure the transverter. In reading the text, I'm finding some difference's based on my set-up.
I'm trying to TX/RX on a single antenna and using the K60XV for a low level drive of 1milliwatt. Some of you guys who are running this set-up please tell me if I'm on track. Here's the set-up I'm using: JP1 pins 1&2 JP2 pins 1&2 JP3 pins 1&2 JP4 pins 1&2 ( bypassing the attenuator ) JP5 pins 2&3 JP6 pins 2&3 ( enabling Q6 ) JP7 no shorting block installed JP8 shorted JP9 pins 1&2 ( I don't have the crystal oven yet ) This will allow me to run one jumper cable from the " OUT " port of the K60XV to J3 " TX in / 1IF " on the XV50. The RXout / 2IF is then used to daisy chain to other transverters. Command signals are via the AUX BUS and course the antenna hooks to the transverter J1. YES / NO ?? any suggestions ?? Thanks and 73: Jerry N0JRN ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
