Hi everybody, I recently started building a K2 and I've just finished the assembly of the control board. My resistance checks are all within specs except two of them are just a little bit off. My readings at pins 29 and 30 of U6 are a little bit higher than those listed in the table. (I'm getting about 96.3 K and the table lists 70-90 K.) I think that these readings are probably OK, but I thought that I would ask someone who has "been there and done that." Is there any need to be concerned about these checks?
Thanks in advance and 73, Paul - N8XMS ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
