Thanks Randy. You should be sure the traces are cut. That step was added in the last update and I didn't change the reference in the previous step to say "go directly to the next step below" rather than to the next page.
Sorry for the confusion. Ron AC7AC -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Randy Moore Sent: Sunday, December 06, 2009 10:10 AM To: Elecraft Discussion List Subject: [Elecraft] [K3] KRX3 install question? I'm installing a KRX3 in K3 #2006 and have a small confusion. I'm on p. 20 of the KRX3 installation manual. I have confirmed that R91 has a value of about 22 ohms (21.9 on my meter). The 4th step on the page says that if that is the case, skip directly to the next page. Being curious, I looked at the next step on p. 20 which talks about cutting some traces if they have not already been cut. On my board, these traces are NOT cut. But it looks like I have been directed to skip this step. So should I cut the traces or not??? 73, Randy, KS4L ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
