Larry, One of my K3's had solder in the holes and one didn't. With the one with solder in the holes I just put the component lead (after trimming and tinning) in the center of the hole and put the soldering iron tip on the hole and lead. This melted the solder and the lead pushed into the hole.
N2TK, Tony -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Larry - K2GN Sent: Sunday, September 27, 2009 1:02 PM To: Elecraft - K3 Subject: [Elecraft] VFO Tunning Noise Reduction MOd I have my K3- S/N 3278 open on the bench to do this mod. I find the via holes near C66 not open. They have been soldered from the other side. Is this an indication that this mod was down before it ship to me 7/10/09?? Or should I just tack on the resistor/diode to them? de K2GN/Larry K3 - S/N 3278 ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
