Start up SDR. Then push the setup button and the cat submenu button when it comes up. You'll then see a choice of which com port you wish to use along with the other parameters that are necessary to be set up. That should do the trick.
Bruce-W8FU -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Gregory Fischer Sent: Friday, July 31, 2009 6:16 PM To: Elecraft Reflector Subject: [Elecraft] SDR-IQ users? Looking for some assistance in setting up SDR-IQ. I ran the setup and connected the IQ and it is receiving sigs from the K3's IF. The problem is I cannot get it to communicate with the K3 to follow frequency changes from the radio....or when clicking on a signal to have it change the radios frequency. I would have thought that after the setup I would find something for the SDR-IQ in the device manager but I don't.....no com port setup for it or anything. Did I miss a step somewhere? THanks Greg AB7R ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
