Check out the SWR plotter in K3_EZ, the author did a pretty nice job with it!!
Terry ----- Original Message ----- From: Dick Dievendorff To: 'Chuck-NO5W' , [email protected] Sent: Fri, 3 Apr 2009 16:45:45 +0000 (UTC) Subject: Re: [Elecraft] Is K3 SWR Available via CAT Commands I read the SWR during the Tx Gain calibration procedure with the ATU (if present) in BYP. I have set the Tune Power to a specific level (5 or 50 watts in TxG calibration) and then I do the CAT command equivalent of pushing the TUNE button. SWR appears in the VFO A area, which can be read with DS; Dick, K6KR -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Chuck-NO5W Sent: Friday, April 03, 2009 8:52 AM To: [email protected] Subject: [Elecraft] Is K3 SWR Available via CAT Commands Is it possible to read the K3 SWR via CAT commands with the ATU bypassed? I saw a similar question for the K2 in the archives but nothing on the K3. 73/Chuck/NO5W ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
