PTT RLS is the delay between you releasing the PTT and the K3 changing from TX to RX. It is used in ARQ data modes such as Amtor or Pactor to allow time to clear the data from the TX (DSP introduces delays in the K3 IF). The values are in milliseconds, typically set to 012 for using an SCS PTC Pactor modem. If you don't use Amtor or Pactor leave it set to the default of 020. All these commands are explained on the K3 by pressing DISP when in the menu.
73 Dave, G4AON K3/100 #80 ------------------- In "CONFIG "menu, i've modified, by error, the "PTT RLS" parameter; old value was ??? and now i've set to "002". I don't find on my K3 (#1212) manual rev C1 the use of this parameter. I know i could reset to the previous parameter setting, but i would prefer to know the significance of "PTT RLS". Thank you for your help. An Happy New Year! 73 QRO fr Rudolf, HB9ARI _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
