You have the satisfaction of knowing that your're right on the mark then. Well... at least very close. AND you've been spot on the whole time you've had the K3.
Suggestion: Find somewhere else to tinker. The S-Meter is a good target. There has been some debate on that. Same with AGC adjustments. There is a lot to do here with the K3. Operating it is the best part. I think Elecraft has found us a whole new hobby, or a set of them. 73, matt, W6NIA K3 #24, K2 #2810, etc. On Mon, 15 Dec 2008 20:39:28 -0800 (PST), you wrote: > >The multimeter *did* read 5.007 volts but I couldn't enter the additional 7mV >into the K3. Talk about annoying.... > > >Matt Zilmer wrote: >> >> Just use a different (uncalibrated) DMM.... Then you can change the >> setting _twice_! >> >> matt zilmer, W6NIA >> >> On Mon, 15 Dec 2008 18:07:07 -0800 (PST), you wrote: >> >>> >>>Don't you hate it when your calibrated multimeter displays 5.00V on pin 2 >of >>>the ACC connector and you then don't have a reason for altering the >setting? >>>I feel like I've missed out :) >>> >>> >>>----- >>>Shane >>>K3/10: S/N 2127, KBPF3, KFL3B-FM, KFL3A-6K, KFL3A-2.8K, KFL3A-400, >KTCXO3-1 >>>& KXV3. >> _______________________________________________ >> Elecraft mailing list >> Post to: [email protected] >> You must be a subscriber to post to the list. >> Subscriber Info (Addr. Change, sub, unsub etc.): >> http://mailman.qth.net/mailman/listinfo/elecraft >> >> Help: http://mailman.qth.net/subscribers.htm >> Elecraft web page: http://www.elecraft.com >> >> > > >----- >Shane >K3/10: S/N 2127, KBPF3, KFL3B-FM, KFL3A-6K, KFL3A-2.8K, KFL3A-400, KTCXO3-1 >& KXV3. _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
