Wyn,
There is no kit or PC board specific to the K1, but the same amp keying
circuit used for the K2 should work if the K1 6R signal is used as input
in place of the 8R signal used in the K2. Where you pick up the
required voltage and ground inside the K1 and how you mount it is an
exercise I will leave to the builder - but electrically, the circuit
should work fine.
I cannot comment on the relative timing of the presence of the 6R signal
to the onset of RF, but I imagine it is adequate to handle all but the
slower relays in an amplifier.
Why don't you try it and report your implementation.
73,,
Don W3FPR
Wyn Hughes wrote:
Hello group,
Does anybody know whether the K1 can be modified to provide a keying
output, to key a small external amplifier (similar to the available
mod for the K2)?
73,
Wyn, VR2AX
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
