My concern, if I have read the spec correctly, is the 40M sample/sec. I assume that is the max rate (ie not 2x 40Ms in dual mode) because the usual aim is to make the spec look good! So, even in single channel mode, that is a display bandwith a bit under 20MHz. Not entirely surprised, very fast sampling costs. Also note it is 8 bit. Fine in scope mode but if planning to use an FFT and consider spectrum analysis, 8 bits is not that high a dynamic range. A very careful 'what do I want this for' is appropriate. Regards 73 Alan G0HIQ
--- On Sat, 13/9/08, [EMAIL PROTECTED] <[EMAIL PROTECTED]> wrote: Message: 26 Date: Sat, 13 Sep 2008 12:05:55 +1000 From: "Mike Walkington" <[EMAIL PROTECTED]> Subject: [Elecraft] OT - PC Oscilliscope Performance All, Just found this PC based oscilloscope http://www.bitscope.com/product/BS310/ and wonder what you think of it. Yes you are limited by needing a PC, but the waveform generator, spectrum analyser and logic analyser functionality seem to be most versatile. Mike VK1KCK _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
