Hi All,
I had to go find an old Stanley cross head screw driver, as the posidriver
was not a good fit. Having looked at the old Stanley driver #810 I can see
that the cross sides are quite tapered as compared with the posidriver and
this probably the reason for the better fit. If anyone is "Camming Out" on
the small screws on the K3 they have got the wrong driver or using far too
much force.
I found out about too much force on small bolts when turning the hexagon off
1/4" BSW bolts when I was an apprentice marine engine fitter, where large
amounts of force are quite often required.
73
Tim
GM4LMH
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
