Aren't the sockets always "straight", with the pins (the part that
attaches to the PCB) either right angle or straight? check pages
1328-1329 of the Mouser Catalog 634 (May-July 2008) for a selection of
3M connectors that will probably fill the bill.
- Jim, KL7CC
Kevin Rock wrote:
I have been searching through Mouser and other catalogs for something I know exists. I
have seen examples in both Elecraft kits and in other kits I have built. Now I want to
find these parts for a project I am designing. I want a set of 0.1" right angle
header and sockets. I am able to find the pin headers but cannot find the matching
sockets. Where do I find right angle sockets to mate with the 0.1" header pins? I
don't really want to change my design to use straight pins and sockets but may have to if
I cannot find what I want. Thus I am asking for direction: where do I find the parts I
know exist? I am probably not calling them the right thing but have tried a number of
different names over the last four hours. Any assistance would be appreciated.
Kevin. KD5ONS
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
