Joe Subich, W4TV wrote:
A 6 kHz filter (AM) on the RF board is required to use ESSB,
either in RX or TX mode.
What about the FM filter for transmit and receive? It's better
than the typical 20 to 40 KHz wide 70 MHz filter in other rigs.
Hi Joe,
We do plan to allow the FM filter to be used for AM and ESSB
eventually. But this will require additional firmware changes and a lot
of careful testing. I have several other tasks to complete before I can
get to it.
73,
Wayne
N6KR
---
http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
