Based on this, I thought it might be on the Tudo list. But then I
recall a firmware fix that addressed a cross-band problem. So I'm not
sure if they are addressing that issue, or the using A/B between bands
issue.
<http://n2.nabble.com/K3%3A-VFO-B-follows-band-changes-on-VFO-A-td466460.html>
David Wilburn
K4DGW
'Never argue with an idiot. They drag you down to their level then
beat you with experience.' - author anonymous
S Sacco wrote:
David -
As you say, "it is supported with the sub-receiver".
You answered your own question.
The next question is: "Is it worth $500 for this feature?".
So far, I've decided against...but then again, I have two K3's, and
have them set up so that the 2nd K3 can on any band the 1st K3 is not
on.
73,
Steve
On 7/31/08, David Wilburn <[EMAIL PROTECTED]> wrote:
Amazing what you remember right after hitting the send button. Like putting
K3 in the subject.
David Wilburn
K4DGW
David Wilburn wrote:
Is it possible to set VFO A to one band, and VFO B to a second band? I
recall some discussion about this in the past, but do not remember if it was
on a tudo list, or if it will be a limitation.
As an example, place VFO A on the 20m band CW mode, and VFO B at a
location on the 40m band CW mode. I have done this with other rigs, is
there a menu setting I am missing, or a limitation of the rig? I just did a
couple of quick searches through the documentation, but I did not see a
reference to it.
I am using the 2.20 firmware. I see that it is supported with the
sub-receiver.
It is handy during a contest to set VFO B to another band, and bounce
there periodically to check activity / propagation, while CQ'ing.
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
