Manuel,
Yes, set the configuration menu (while in SSB mode) parameter for VFO
CRS to 1.0
Values of 0.1, 1.0, 2.5 and 5 are available for SSB. VFO CRS is
settable per mode.
After setting VFO CRS to 1.0, pressing COURSE will toggle between 1.0
kHz steps and 50 Hz steps, but the RATE and FINE buttons interact too
giving a range of steps from 1 Hz to 1 kHz.
Once you make your selections, a bit of practice may be required to take
advantage of all the capability available - but if you only want 1 kHz
steps, all that is needed is to zero the low order digits and press
course and you will traverse the band in even 1 kHz increments.
73,
Don W3FPR
Manuel Maseda wrote:
Hello,
Can someone tell me if the K3 can be configured for a 1K VFO step size in
SSB mode?
Thanks,
Manuel W4SSB
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
