Hello,
normally I use a Heil Pro-Set with IC-4 and the red Kenwood-adapter for
my K2 and for my K3 , too. Now I decided to buy a cheaper headset for
my K2 which I do not use very often.
I bought a computer-headset which has a modified connector and it should
be ready for kenwood-rig-operation
(http://www.eurofrequence.de/mikrofone/page2.html ED 5 sw). The
microphone is an electrical one, so I settet the jumper 5 on the
frontpanel of my K2. I didn't solder a 5.6kohm resistor between pin1 and
6 of the connector because I will solder it at the headset-connector and
not on the frontpanel.
If I connect the new headset the K2 freezes and ELEC is shown on the
display. Note: the resisior has not been soldered yet. If I remove the
jumper and conect my Heil Proset it works fine.
Any hints?
73 Holger / DL9HDA
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
