Sorry Wayne, I meant to send this to the list.
Has the method "3" been implemented for frequency calibration yet?
Stan Rife
W5EWA
Houston, TX
K2 SN 4216
K3 SN 0690
wayne burdick wrote:
Hi Eric,
This should not have happened. You may need to re-set the filter's
center frequency using the FL5 FRQ menu entry. Typically the 200-Hz
filter has an offset of around -0.90 kHz.
Also make sure that FL5 BW is set to 0.20, and that you have REFCAL
properly calibrated against a reference signal.
73,
Wayne
N6KR
On May 4, 2008, at 10:00 AM, Eric wrote:
Seems I lost my 200 Hz filter after the update. In config the filter
is ON, everything looks OK, but al sigs are lost when FL5 kicks in
when turning WIDTH.
---
http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
