Lernart:
I had a similar problem with my K2 #6272. Gary sent me a response
stating that T1 and T2 could cause
a low power situation on the higher bands IF they were
switch or the turn count was wrong or bad solders ........
I checked all mine and found that I had all turns correct, they were in the
correct location and all solder joints were good.
I expanded on what Gary told me and started checking all related components.
I found I had the wrong value in R10. It was suppose to be 100 ohm and I
had put a 10K ohm resistor in that spot.
Correcting the resistor error corrected the problem.
Check you schematic and check all the components related to T1 and
T2..........
YMMV but it's worth a look.
72 Jerry N0JRN
On 4/13/2008 5:00:20 AM, Lennart ([EMAIL PROTECTED]) wrote:
After I installed the K2 SSB adapter I get half or less power on all
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
