There is apparently some confusion about how the K3 ALC works. Just to
help muddy the waters a bit, I'll toss in what little I know about it.
We recommend setting the Mic (or LINE IN) Gain so you get 5 bars of ALC,
with possibly the 6th bar occasionally flickering, with CMP set to 0.
No, this is not to ensure you have Tx distortion! Just the opposite, in
fact.
In this case, the ALC meter display is acting as a "VU Meter" and is
being used to help you set the Tx audio path gain correctly. It is not
showing you how much you are over-driving the PA. This is why you can
set it up in Tx test mode, when you are not transmitting any RF at all.
If you have a little too much drive, the DSP will scale things back at
the output of the mic amp. Thus at the 5th ALC bar, the DSP is at the
threshold of gain compression. At the 6th bar, it is cutting back gain
by 6 dB or so.
Assuming SSB, after the Tx signal is created from the audio, it
optionally goes through an IF clipper. This is engaged by setting CMP to
a value other than 0.
After the optional clipper, the signal goes through a 15 kHz IF filter
followed by a gain section in the DSP, and is then output as a 15 kHz
signal to the rest of the Tx strip.
From this point, the MCU watches things and if it sees power levels
going awry, severe mismatch, etc., it cuts back the drive to the Tx
strip in the DSP. Thus, the Tx strip is running at nominal gain
regardless of the power level. OK, if you go below 12 watts you are
using the LPA and not the HPA, so the Tx strip gain is less, but you get
the idea. What we are *not* doing is varying the bias on an IF
amplifier somewhere that might change its operating point and possibly
introduce additional distortion. The point in the DSP path where the
change in drive is commanded is linear to the limits of 32-bit floating
point math and the resolution of the Digital to Analog converter.
Enjoy!
73,
Lyle KK7P
[ Note: For PSK and other operation, you want to set things to the level
where the 5th bar just comes on -- or just doesn't. If you have only 4
bars in digital modes, that's OK. With less than 4, you are under-
driving things and the ALC will kick in to bring up the power level to
the amount you requested. If you try and trick the system and run with
*zero* ALC bars in PSK31, the ALC has to work hard to give you your
requested power - or maybe it will think there is insufficient signal to
work with - and your Tx S/N may suffer. So, *please* set it to 4 bars
in soundcard "digital" modes. ]
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
