Jay,
I suggest that you review the K2 Dial Calibration article on my website
http://w3fpr.qrpradio.com and then do a full calibration run including
the SSB filters using Spectrogram.
If that does not correct it, then re-do the calibration. The VFO and
the BFO are about the only thing that could effects you describe. Be
quite careful to place the low frequency corner of the SSB filter
passband at 300 Hz and you should be 'on frequency'.
You may want to listen to yourself in another receiver when you are done
rather than depending on reports from others on the air.
73,
Don W3FPR
Jay wrote:
It's been so long since I studied the manual, maybe someone can
refresh the step I need to do (so I don't have to relearn the complete
alignment process). On lower SSB I'm being told I'm 100 hertz low
transmitting, but the receiver is just fine. I don't want to mess up
my cw settings since everything is perfect (for me). Any help moving
my transmit sig up 100 hertz (w/o using XIT!) would be appreciated.
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
