Just a minor problem and looking for some advise.
All resistance checks are fine. All voltage checks are fine except Pin 27
on U1
It's showing about .5 volts.
Also noted that the LED on the K2 is at the top of the scale.............
Based on the charts in the back of the KPA100 manual, Pin 27 should go
low when the amp is in TX.
The LED on the K2 seems to support the fact that hooking the amp up puts
the rig in transmit.
Naturally, I have some digging to do but was curious if there is anything
in particular I should be looking at.
Also, I had the power adjusted on the K2 to around 10 watts while doing
these tests.
Is it possible for the KPA100 to sense the power level of the rig and go
into TX.
Any thoughts??
Thanks and have a great weekend all
72 Jerry N0JRN
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
