Hello I'm assembling my second K2 and am having a bit of a problem. I am more of an operator than techniciation. Everything went good up until the second test. At that point my BFO wasn't working. While trying to find out why it wasn't working, I did something that made the frequency counter and volt meter stop working. First off, my 8 volt regulator on the control board is only putting out 7.6 volts. Is that enough to work ok? Second, none of the voltages on control board U2 are anywhere near where they should be, except pin 8 which is 7.63 volts. Pins 1,2,and 3 have 3.4 volts instead of 6.9. Pins 5,6, and 7 have only 3.69 volts instead of 7.3. Control board U7 has 0 volts instead of 5 volts on pin 5, and 5 volts instead of 0 volts on pin 6. Could this be another manual error, it says they should be the opposite. U6 has the voltages on pin 24 and 25 reversed, according to the manual, pin 24 actually has 0 volts and 25 has 4.9 volts. Could any of this be my problem, or am I looking in the wrong place like I normally do! Any help appreciated. 73 Scott N5SM
_______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
