Harry, You could develop a macro for this and use it in Command Mode with the K3 Utility. Command Mode is a very useful facility for this sort of thing.
Currently, power level sticks across bands and you'd have to reset it by hand for 6m, or develop a standard set of macros to preset power level, mode, Lo/Hi, etc. for given bands of interest. matt, W6NIA k3 # 24 On Sat, 23 Feb 2008 13:22:05 -0500, you wrote: >Hi, > >I asked this question here before but no one anawered it. Maybe it was >considered a dumb question. > >Can the power output level of the K3/100 be individually programmed for >different bands? For example to accomodate a low drive level 6M amplifier. I >doubt it but thought I would ask as I cannot find anything in the literature >on this. > >It would be nice so that when you QSY'ed for a 6M band opening you would not >over drive your 6M amp in the excitement. >_______________________________________________ >Elecraft mailing list >Post to: [email protected] >You must be a subscriber to post to the list. >Subscriber Info (Addr. Change, sub, unsub etc.): > http://mailman.qth.net/mailman/listinfo/elecraft > >Help: http://mailman.qth.net/subscribers.htm >Elecraft web page: http://www.elecraft.com _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
