Me too! The external Ref is very important to my QRSS QRPp very weak signal work to maintain my frequency tolerance to less then .1 hz. I am currently using an HP 3325A Synthesizer and HP Z3801A GPS Ref to put a stable and accurate signal on the air! Also have my RX340 referenced to the Z3801A Not having the external reference opt is a big setback! I hope the ability to reduce the output power down to -15 dBm using the KXV3 is still possible?
Larry Putman WB3ANQ Pasadena, Maryland FM19rc www.wb3anq.com ----- Original Message ---- From: Jerry T. Dowell <[EMAIL PROTECTED]> To: Philip Theis <[EMAIL PROTECTED]>; [email protected] Sent: Saturday, February 23, 2008 9:17:39 AM Subject: RE: [Elecraft] K3 External Reference input You bet! That is one of the reasons I bought a K3. Jerry AI6L -----Original Message----- From: Philip Theis [mailto:[EMAIL PROTECTED] Sent: Friday, February 22, 2008 4:50 PM To: [email protected] Subject: [Elecraft] K3 External Reference input Is there interest among the group for the necessary parts to input a disciplined 10MHz signal to control frequency? We all know there is a place holder on the back panel, but Gary just told me there were no plans. In April Wayne said it was coming but the price hadn't been set. Just wondering if anyone else out there has an interest like I do. 73, Phil K3(352)TUF ____________________________________________________________________________________ Never miss a thing. Make Yahoo your home page. http://www.yahoo.com/r/hs _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
