Joe,
I believe that would have to be done with the IF filter alignment CAL
FIL. With Spectrogram or similar, you can observe not only the center
of the passband, but you can compare the filter slopes. There will be
some difference between the upper and lower slopes, especially at wider
bandwidth settings, but you should be able to achieve an acceptable
compromise.
73,
Don W3FPR
Joseph Trombino Jr wrote:
I recall there being a way to equalize the K2 audio response between
NORMAL and REVERSE in the CW mode but can't for the life of me
remember what the tuning procedure was.
Can some kind soul point me in the right direction to the above
procedure???
73, Joe W2KJ
I QRP, therefore I am
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
