On Nov 28, 2007 3:17 PM, David Ferrington, M0XDF <[EMAIL PROTECTED]> wrote: > I second all of these. I will be using 2 mcs too and I have an SGC I wish to > tune, I'd like to be able to set the 'low rf output for tune' level as well, > the SG-237 will tune on 3W.
I can tune my MFJ magnetic loop using 1W and reading the SWR off the KAT2 in CAL S mode. But it's really annoying to do this and hear the KAT2 start clicking away because I'd switched to the other antenna and put the KAT2 on AUTO again and forgotten to switch it off when going back to the loop. If the KAT3 could be configured separately for the two antenna sockets, that would be a big plus for me. -- Julian, G4ILO K2 s/n: 392 K3 s/n: ??? G4ILO's Shack: www.g4ilo.com Zerobeat Ham Forums: www.zerobeat.net/smf _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
