Wayne Burdick wrote:
The KBPF3 extends coverage to 0.5-30 MHz continuous, except for a small
gap right around the first I.F. (8.215 MHz). It has no impact on the
6-meter coverage (specified from 50-54 and tunable down to 48 MHz).
On the subject of 50MHz, Wayne, please could you say more about the
receiver sensitivity specification?
At present the sensitivity spec is the same on all bands, namely: "-136
dBm (typical), preamp on, 500Hz b/w". Assuming that figure represents
the noise floor, it is more than adequate for HF (and maybe even 'too
good' for the lower bands); but in VHF-speak it translates to a noise
figure of 13.6dB, which is less than stellar.
Could you comment, please?
--
73 from Ian GM3SEK
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
