I had to purchase some odd sizes of Phillips drivers and found a good selection at SEARS. They had them listed by the numbers
Dave David J Drew -- W7DPW Over 50 Years with Same Call Amateur Extra Since 1970 Continuous ARRL Member Since October 1957 ARRL Life Member October 1969 Vancouver, Washington 98664-4445 ----- Original Message ----- From: "Mike" <[EMAIL PROTECTED]> To: <[email protected]> Sent: Wednesday, August 29, 2007 4:00 PM Subject: [Elecraft] OT: Miniature screwdriver sizes > I'm in need of a very small phillips screwdriver, but haven't been able to find actual dimensions of them and I don't know what size a "#0" would be, etc. I thought someone on this board might have some advice. The slots in these screws are .064" or 1.63mm. Any help would be greatly appreciated! > > -- > 73, > Mike, KC0KBC > Yaesu FT-857D, FT-8800R, VX-7RB > Elecraft KX1 #1819, XG2 > _______________________________________________ > Elecraft mailing list > Post to: [email protected] > You must be a subscriber to post to the list. > Subscriber Info (Addr. Change, sub, unsub etc.): > http://mailman.qth.net/mailman/listinfo/elecraft > > Help: http://mailman.qth.net/subscribers.htm > Elecraft web page: http://www.elecraft.com _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
