Wayne, given that 49.380 isn't a readily available calibration freq like, say, WWV, how does a ham in the field check or set it if needed? 73, Bob N6WG
----- Original Message ----- From: "wayne burdick" <[EMAIL PROTECTED]> To: "Ron Durie" <[EMAIL PROTECTED]> Cc: <[email protected]> Sent: Wednesday, August 29, 2007 8:59 AM Subject: [Elecraft] Re: K3 Reference Oscillator > 49.380 MHz. All signal sources are phase-locked to the refernce. Fine > adjustment occurs in firmware, and once calibrated, it's accurate to > about 1 Hz through 6 meters at the calibration temperature. The > high-stability option is at the same frequency, with firmware > correction to better than 0.5 ppm. > > 73, > Wayne > N6KR > > On Aug 29, 2007, at 8:51 AM, Ron Durie wrote: > > > What is the operating frequency of the K3 TCXO reference oscillator? > > > > > --- > > http://www.elecraft.com > > _______________________________________________ > Elecraft mailing list > Post to: [email protected] > You must be a subscriber to post to the list. > Subscriber Info (Addr. Change, sub, unsub etc.): > http://mailman.qth.net/mailman/listinfo/elecraft > > Help: http://mailman.qth.net/subscribers.htm > Elecraft web page: http://www.elecraft.com _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
