On Mon, 20 Aug 2007, Don Wilhelm wrote:
Check L33 and the crystal leads for good soldering. Be certain D18 and Q19
are oriented correctly and well soldered. Check the varactors D16 and D17
for proper orientation, proper types (D16 large and D17 smaller) and good
soldering. Measure the resistance from Q19 source to ground - if it is much
larger than 270 ohms, check the lead tinning on RFC14 (remove it and re-tin
You did it again Don! That was the hint I needed - all because of RFC14,
which I had recently re-wound. Since I had re-installed that one part, I
had thought it would be the last thing to create a problem. Toroids. :-)
We're now on Part III of the alignment and assembling some mini-modules
for the final push to testing. Thanks very much!
Will
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
