Here's what I do I use double sided PC board material. I design the
Manhattan style PC board I want on paper with the islands or buildings
(squares and rectangles for pads) clearly defined making sure that the
spacing between the components I am going to solder is correct. I then
use good quality tin snips or hacksaw and cut out the islands or
buildings from more double sided PC board material. I transfer the
pattern from paper to a PC board so I know where the pads will go. I
then use Krazy Glue to glue the pads down with one or two very small
drops. I then solder the parts from pad to pad or pads to the ground plane.
Jozef WB2MIC
Ken Kopp wrote:
Check sheet-metal drills at a machine tool supply house..
Their points specifically produce the circles you want. The tip and
the OUTER edge of the cutting face contact the metal at the same time.
I can send you a photo of one if you need.
73! Ken Kopp - K0PP
[EMAIL PROTECTED]
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com