Don, et all;
I'm now wandering around in the menu of "ATU", attempting to make
sure the circuits are working right in the KAT2 that I didn't prove out
a few weeks ago. When the instruction told me "Set the ATU parameter to
AUTO and exit the menu", then "Turn the power off and back on. Use the
menu to verify that the ATU parameter is still set to AUTO."
I found that I had to find "ATU" again, and noted that the parameter
is set to "AUTO", so I'm hoping that the system is doing OK. I'd hate to
have to look at U2 on the ATU, try to sniff out yet another problem with
a solder connection!
Gee, this started out to be a fun project, and now I'm having to
double check every tiny item that's in doubt. Does anyone have a
different reading than I have?
Tnx, 73's
Gil WA5YKK
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
