Some of us will be nice...
4800 bps, 7 data bits, although 8 will work (you will need to strip
off the msb). 1 stop bit (2 will work), no parity, no flow control.
It is a very forgiving interface for low-level format.
The info is in the KIO2 manual and detailed info in the KIO2
programmer's guide. Be careful reading that programmer's guide - it
will lead to using up lots of your time when you start crafting the
latest great rig control program, ;-)
On Jun 25, 2007, at 6:21 AM, Michael B wrote:
What are they parameters for the K2 serial ie. baud rate, data
bits, parity,
stop bits, and flow control?
--
W2CVZ,
Michael
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
- Jack Brindle, W6FB
------------------------------------------------------------------------
---------------------
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
