Hi to the List,
OK here goes when I use the power dial to adjust the Power out on the
K2 I get on the LCD the keyer speed being adjusted.
This also happens when I use the keyer dial.
I've checked that every thing worked fine and dandy up to the stage 2
alignment (40m receive).
I 'm not sure where I've mucked it up as I can't see any
shorts,components not soldered or components in the wrong place on
any of the boards.
At present I'm stuck on the 40m transmitter alignment so haven't set
up the other bands for receive or transmit yet.
Any ideas/suggestions what to check greatly appreciated. :)
73 Gary
Gary McKelvie
G7USC
Web : www.garym.org.uk
Mobile : +447968501863
MSN Messenger : [EMAIL PROTECTED]
So Long and Thanks for all the Fish
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
