A quick question for an experienced (or anyway, confident!) builder: I am winding the first toroid,RFC14, for my K2 and seem be be inadvertently stripping a bit of the red enamel off the wire when I sew it through the toroid. I don't remember having this happen with the KX1. It appears that the inside edges of the ferrite toroid are kind of sharp. I can avoid it by being EXTREMELY careful while winding. Does it matter if a tiny stretch of insulation is missing? I.e. should I start over whenever I encounter this? TU es 73 Eric N0HHS KX1 #670 K2 #6106 (in process) _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
