I hope (and expect) that the K3 has more robust headphone jacks. 73, Bob N6WG
----- Original Message ----- From: "Lyle Johnson" <[EMAIL PROTECTED]> To: <[EMAIL PROTECTED]> Cc: "ELECRAFT" <[email protected]> Sent: Friday, May 04, 2007 5:17 PM Subject: Re: [Elecraft] K3 > > If using an external receiver with K3 is the RX ANT OUT the correct connection to get signal to the external RX? > > Yes. > > > I see a PHONES connector on rear panel. If used how does one switch between speaker and headphones? I like the idea to get MIC and HEADPHONES off the front panel. > > Plug in headphones to either the front or rear phones jack and the > speaker is muted. > > > Is the PA circuit breaker readily available if needed? > > Yes, it is on the rear panel, part of the fan assembly. > > > Can ANT1 and ANT2 be set and stored by band? > > Yes. > > 73, > > Lyle KK7P > > (I'll let someone else answer the first two questions you asked.) > > _______________________________________________ > Elecraft mailing list > Post to: [email protected] > You must be a subscriber to post to the list. > Subscriber Info (Addr. Change, sub, unsub etc.): > http://mailman.qth.net/mailman/listinfo/elecraft > > Help: http://mailman.qth.net/subscribers.htm > Elecraft web page: http://www.elecraft.com _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
