Dear all,
After a lot of checking and checking I still have this problem. I
removed T4 and did dubble check. I did replace the coax cable by a
teflon coax cable. I did set R26 and R27 to 43K. Sometimes when turning
C1 it is possible to set 1.0-1 but than it reduces the power to 0 watts.
After switching off and on again the display is saying Hi Curr again.
I'do not know any alternatives anymore. Please help!
73, Koert PA1KW
-----------------
"HAMRADIO - when everything else fails!"
Koert Wilmink wrote:
Dear all,
I just finished my KPA100. I do have the following problem with the
first steps connecting the KPA100 to my K2 #05618.
I've connected the ribbon cable, speaker and RF connector to my K2.
I've got audio and I also receive stations when I connect my antenna.
With my dummy load and after setting power to 5Watts on 40M I see the
5 watts and the SWR for 1 second in the LCD screen and then the HiCur
(High current) appears on the LCD.On 20m bands I only see the PWR in
the LCD screen without the SWR for 1 second and than I see HiRefl. On
10M I do see the pwr and the SWR! The latter I only get 2.1 watts when
set to 5 watts.
Please can somebody tell me where to start? I did check the
connections and this seems to be ok. There is no pwr to the KPA100 so
everything is bypassed, except the bandfilters?
help is very much appreciated!.
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
