Hi Folks,
I have a strange behaviour with my K2 #6026 in the alignment and test
procedure at page 43 of the manual. All went ok, untill after power up I
tapped Display, the display said St L 040 and stayed in that menu, untill I
tapped Menu, then everything was normal and stayed normal - untill next
power up. I tried to reset the EEPROM, by powering up with 4+5+6 held, but
this had no effect. It seems nothing is reset. All other tests went ok.
I checked and rechecked soldering.
If anyone has an idea, please.
73, Gerard PA1GP
[EMAIL PROTECTED]
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
