So far I have been soldering in a space of about 2' x 2', and building
in a space of about 1' x 4'. I have sorted the parts out into a couple
of plastic containers (not the ESD sensitive stuff). I have the
container laid out to the side, and the card in front of me for
building. It is a bit more cramped than I would like to be, and I put
all the stuff up when I am not building as the table is the keyboard
area for this computer and my work computer. Not an optimal setup, but
it is working so far.
David Wilburn
[EMAIL PROTECTED]
Wyn Hughes wrote:
Does anyone have a smaller bench?
Search against 'vr2ax' in qrz.com (recently updated entry)
It is actually a real photo and my idea of 'multi-tasing. ' I had built and
tested the control and front boards when the photo was taken, was wondering
where to fit the larger mainboard.
73
Wyn, VR2AX
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
