Larry, The toroid cores are non-conductive, so if the bare wire of the end turn is tinned it is not a problem, BUT if you also bared the wire of an adjacent turn so you could have a one turn shorted to another on the winding, that is not good and you will have to rewind.
73, Don W3FPR > -----Original Message----- > > Hello everyone, > On the 160M module, toroid L1 .I managed to burn off just a > little too much enamel insulator from 26ga. wire.........Bare > copper into the 1st 1/2 turn on the toroid. > Am I o.k.? Or should I rewind? > Tnx > from new guy ,just starting out. > W1EGJ > Larry Wright > _______________________________________________ > Elecraft mailing list > Post to: Elecraft@mailman.qth.net > You must be a subscriber to post to the list. > Subscriber Info (Addr. Change, sub, unsub etc.): > http://mailman.qth.net/mailman/listinfo/elecraft > > Help: http://mailman.qth.net/subscribers.htm > Elecraft web page: http://www.elecraft.com > -- > No virus found in this incoming message. > Checked by AVG Free Edition. > Version: 7.5.441 / Virus Database: 268.18.2/692 - Release Date: > 2/18/2007 4:35 PM > -- No virus found in this outgoing message. Checked by AVG Free Edition. Version: 7.5.441 / Virus Database: 268.18.2/692 - Release Date: 2/18/2007 4:35 PM _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
