I just finished the PLL mod board, working through the RF board construction on K2 #5945. I made the solder pads on the back of the small board as small as I can and even then it looks like they'll touch the capacitor that is right behind that board. Makes me think a shot of silicone in there might be prudent. Same on the U6 side, everything is extremely close there.
Thoughts? Did any of you use some sort of insulation there? Thanks, -Jeff KA6LAF _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
