My K2/100 flashes the High Current warning on 20 meters. This is the only
band it happens on. The current is 3.98 and power 97 watts, much higher
current and lower power than all other bands. Do I need to re-align C21 and
C23 or could there be something else wrong? Could the problem be a
mis-alignment of R26 and R27 in the KPA100? Again, 20 meters is the only
band affected. All other bands are no higher than 3.00. I'm using an
Astron RS20-A power supply.
Thanks and 73,
Bill NZ0T
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
