Dear OM Mark K1RX,
The tuning rate of the K3 RIT/XIT basically follows the rate of the main VFO.
Here are a few comments from one version of the operating manual:
VFOs and RIT/XIT
• RATE {21} selects 10 or 50 Hz VFO/RIT tuning. See VFO menu entries, pg. 57.
• FINE {21} selects 1-Hz steps. COARSE selects large steps (MAIN menu, VFO CRS).
FINE Select 1 Hz tuning for both VFOs and RIT/XIT offset
VFO CRS Per-mode Per-mode coarse tuning rate (hold COARSE and tune VFO A or B).
Tap 1 to turn
rounding on/off. Also applies to the RIT/XIT tuning knob if CONFIG:VFO OFS is
set to ON, and both RIT and XIT are turned OFF.
73, Paul W8TM
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to arch...@mail-archive.com
