Guy, VK2KU wrote: I have had an XV144 transverter for a couple of years, and have been very happy with it. It has the Oven option for the 116MHz LO crystal.
I have noticed a frequency error on my overall system of about 200Hz, but have been unable to track this down properly until I had a good GPS-locked Signal Generator and Counter. Careful measurement now shows that the Transceiver calibration is only 10Hz out (pretty good!), whereas the crystal frequency in the XV144 is 115.999 814 MHz, which is 186Hz low. This may not seem much, but in these days of really narrow band working it is irritating. I can of course calibrate it out by setting the transceiver high, but has anyone got a fix to trim the crystal frequency upwards? There is no provision in the circuit for frequency adjustment. --------------------- The is an adjustment, Guy. It's in the K2, not the XV. You have an offset adjustment in the TRN menu in the K2 that allows you to adjust for any offset. Go to the trn number you have assigned to your XV144 in the K2's menu, Press MENU so On is underlined, then tap DISPLAY to cycle through the other menu options for that transceiver. One of the settings is OFS or "offset" which allows you to compensate for any reasonable error in the XV's L.O. frequency. Ron AC7AC _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
