On 10/28/2023 2:29 PM, John Overbaugh wrote:
Messing around with PSK today and I'm stumped... I am sure I just switched
a setting somewhere but I can't figure out where. When I am in DATA A mode
for PSK, I see the CWT meter, not the ALC meter.
ALC shows only in TX mode. For digital modes, the manual says to set
audio drive from the computer to the rig so that ALC reads 4 bars
flashing 5 when transmitting. Digital modes should use the LINE Input.
The correct audio drive setting is a combination of computer output gain
and Line Input gain. When in Digital modes, the Mic Gain knob becomes
Line Input gain. In general, computer output should set at least 6 dB
below 100%.
73, Jim K9YC
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to arch...@mail-archive.com
