Hello All:
I'm putting a NGEN and an XG-2 in a small project case. Assuming that both devices would not be on at the same time, would there be some way to couple the outputs to a single BNC connector, without using a switch, and without degrading the performance of the XG-2? Also will I have any problems with stability by extending the leads for the crystal switch a few inches? Also does anyone know of a source for a small three position single gang rotary switch to mount on the case to replace the switch on the XG-2 board? On a totally different question. Does anyone have any experience with internal lithium polymer battery packs for the K1 or KX1? As always, thanks in advance for all the information I learn on this reflector. Paul N8NOV _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
