AFAICR The KAT500 follows the K3, not the KPA500, as long as the Aux-bus
cable is connected. I can certainly hear the relays click on the KAT500
when I tune the K3 across a frequency threshold point.
73,
Alan. G4GNX
------ Original Message ------
From: [email protected]
To: "[email protected]" <[email protected]>
Sent: 08/05/2021 12:59:03
Subject: [Elecraft] KPA500-KAT500 tuning settings
Hi,
if I switch the KPA500 with the band buttons to another band I would expect the
KAT500 to follow the last tune settings on the new band. However this is not
the case, the tuner switches to the new band settings only when HF goes
through. The 15-p cable is connected and there is no K3 connected.
Is there a menu setting to let the KAT500 follow the KPA500?
73s Steef PA2A
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
