On 2020/06/09 10:27, Keith Onishi wrote:
LPA temperature may be over its upper limit during transmitting FT8.
If so, I would suggest to check and tighten the 3 screws securing 3 LPA
transistors to the rear bottom cover.
73 de JH3SIF, Keith
2020/06/09 9:00、Yoshida Akira <[email protected]>のメール:
Hi all
I have never seen this for many years, however I recently noticed twice
when transmitting FT8 with 100W. No alarm and error message.
When I simply push POWER button in front panel then it turns ON again.
PA temp, DC voltage and DC current looks good. I do not believe RFI
cause this problem.
Any idea ?
--
73 de aki
JA1NLX
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
--
73 de aki
JA1NLX
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
